Blacksheep32

Anybody have the cupseal fail? It's the seal on the metal pin that is hit by the hammer.

__________________
Inflictum angelus, Invito diabolus

Fets

I have never seen that... not on my A5 for sure.

__________________

Sloppy Joe

So basically the valve seat? Only issues I have had with that is over or under oiling... and not pulling the hammer back before airing up... LOL

What's the story behind the question?

sir_snipe_alot

pictures and what gun would be useful

__________________

Fets

Clearly we are in the A5 forum. =D

__________________

Blacksheep32

lol @Fets!

I'll try oiling it more- maybe a thicker lube. What happens is I cock and air up the gun, fire and the gun recocks but air leaks out. I thought I had this problem fixed a while ago when I first got it from Iceman. I'll post up if it works.

__________________
Inflictum angelus, Invito diabolus

sir_snipe_alot

I only check the forums by the You have XX unread posts, not going section by section

__________________

sir_snipe_alot

On that note, are you talking about the rear of the powertube that the hammer hits? If I recall correctly, you need to disassemble your powertube and replace the O-ring that sits behind the washer holding it in.

__________________